Sanyo projectors are equipped with long-life light bulbs, which are mounted in a meeting of special housing for rapid change is certain. You only need a screwdriver, a lamp, and about 5 minutes until you get the projector working again.
1.place the projector upside down on a flat surface, so that the device is disconnected from the network.
2.Locate square plate cover for the lamp. This should be near the front of the unit and clearly labeled as "the lamp cover will be. Remove the two Phillips screws holding the cover plate in place with the screwdriver. Set aside the cover plate and screws.
3.Gently handle the increase in the lamp assembly and housing, and pull the whole assembly to the vertical. Install the new lamp housing by pulling down the socket until it clicks. Replace the cover plate.
READ MORE - To change the bulb in a projector of Sanyo
1.place the projector upside down on a flat surface, so that the device is disconnected from the network.
2.Locate square plate cover for the lamp. This should be near the front of the unit and clearly labeled as "the lamp cover will be. Remove the two Phillips screws holding the cover plate in place with the screwdriver. Set aside the cover plate and screws.
3.Gently handle the increase in the lamp assembly and housing, and pull the whole assembly to the vertical. Install the new lamp housing by pulling down the socket until it clicks. Replace the cover plate.
