How To Get Your Picture-in-Picture TV to Work

Today, many televisions are equipped with image in imaging technology, but it is not always easy for owners to get to work.

Picture-in-picture works because of the TV with two tuners. For photos in picture function properly, you must provide the TV with two signals via cable. It 'easy to do and takes only five minutes. Here's how to get MMS-in-Picture TV to work.

Your first step is to find where does the power cord. You can do this by going to the back of the cable box and follow the cable that is connected to the "in" the terminal.

Just follow the line until you know where to see it. Sometimes, it can have a splitter on the line.

If no cluster is found, disconnect the cable provides, power to the cable box. Connect this cable to the input "terminal on the splitter. In general, the side of the splitter, the only terminal.

Then take a piece of cable and connect one end to one of "Output" terminals on the splitter. Connect the other end of the cable input on back of the cable box.

Here's the hard part. On the back of the TV and see if it has been inputting, two coaxial cables. If there is one, then your dealing with your TV box to connect the cable (with audio / video composite cables red, white and yellow cable).

If your TV has two coaxial inputs are then just another length of cable from the second "out" terminal on the splitter to the second coaxial on the TV screen, and you're done!


If the / V cable is used not to fear, it is easy to gain access to. First, you must remove the cable TV coax. Connect the coaxial cable splitter exit the TV coaxial input.

Enjoy several A / V cable and connect one end of the cable. You will see that the connections are behind the color-coded cable box and labeled. To make sure you put them in the right "there."

Red to red, white and yellow, from white to yellow. If you connect a HDTV, you will use the connectors red, green and blue for video and red and white for audio.


Take the other end of the / V cable and connect to one input of the TV. Again, its color coded and classified.

Remember to connect the input you have, so you and your TV to the intake air to watch the video. For example, if you connected the cable to the input "1," then you have your TV in 1 song to get the signal from.

Set the TV to the correct input and you should get the cable box for power. If you use the PIP button on the remote pop-up window appears with the RSS on the other hand, directly from the coaxial cable.

Remember, only one feed with the programming of cable television. Other food company are the power base (usually up to 99 channels). So it will not be able to see a movie on HBO the tuner and a Showtime film on the other side. (Of course, unless you have two cable boxes!)